System information

Chapter 2 Agent Configuration Mode RADview-PC/TDM Megaplex-2100/2104 User’s Manual
Table 2-26. SW Cfg>> Tab MTML 2/T1
Parameter Possible Values / Remarks
Connect Indicates whether the port should be considered in any of the Megaplex algorithms
No, Yes
Line Type
ESF, D4 (SF)
Line Code The line code parameter of the interface.
B8ZS, B7, TRANS
Interface Interface type
DSU, CSU
FDL Type The side of the FDL that the selected port is located. Response indicates user side,
Command indicates PTT side
Restore Time
(sec)
The time required to restore normal service after the end of a loss of synchronization
condition
1, 10
Line Length Line length
0-133, 134-266, 267-399, 400-533, 534-655
TX Gain (dBm) Attenuation value that brings the signal level closer to the expected repeater signal level
on the cable (only applicable for T1 CSU cards)
0, 7.5, 15.0, 22.5
MTML-2/T1 << SW Cfg Tab
Table 2-27. <<SW Cfg Tab MTML2/T1
Parameter Possible Values / Remarks
Signaling Profile
1,2,3,4,5
Idle Code (hex) Hexadecimal code transmitted to fill idle (unused) time slots in frames transmitted
through the selected port
0 to FF
The following values are not allowed: 0, 8, 10, 12, 21, 24, 42, 49, 84, 92
CGA Method used to signal the carrier group alarm (CGA) state to the other end of the
selected link
None - Non-transparent mode. When one of the links is in out-of-service state, the time
slots carry the appropriate out-of-service code (data/voice OOS) to the other end of the
link.
Trans – When one of the links is in out-of-service state, the time slots carry the
appropriate OOS code to the other end of the link. Signaling bits A and B are not forced
into the OOS state.
Full - Fully transparent mode. When one of the links is in out-of-service state, the state of
the time slots and the state of the signaling bits does not change.
2-50 Agent Port Level Operations