System information

RADview-PC/TDM Megaplex-2100/2104 User’s Manual Chapter 2 Agent Configuration Mode
MTML-2/E1 << SW Cfg Tab
Table 2-30. <<SW Cfg Tab MTML2/E1
Parameter Possible Values / Remarks
Idle Code (hex) Hexadecimal code transmitted to fill idle (unused) time slots in frames transmitted
through the selected port
0 to FF.
Note: The following values are not allowed: 0, 8, 10, 12, 21, 24, 42, 49, 84, 92
Inband Mng Identifier of inband management over the link
Off, FDL or TS0, Dedicated TS, Dedicated TS/PPP, Dedicated FR
Inband Mng Rate
(Kbps)
Data rate of the inband management. Options depend on Inband Mng
8, 16, 32, 64
Inband Mng Rout
Protocol
Protocol of Inband Mng.
For Inband Mng =Dedicated TS/PPP or Dedicated FR:
None, RIP2, Proprietary
Multi Frame
Clock Source
Multi Frame Clock Source group is used to bypass signaling of PCM voice channels
Slot Indicates whether the selected port's Tx multiframe is synchronized with the Rx
multiframe of another port and its slot position.
Local, IO-1..IO-12
Slot must contain an MTML card. If the port is not connected to a TDM bus, this value is
Local
Port Port number in the Multi Frame Clock Source slot (only applicable for slot numbers
IO-1..IO-12)
external-1, internal-1
MTML-2/E1 Connect Parameters
Table 2-31. Connect Parameters – MTML-2/E1
Parameter Possible Values / Remarks
Mediation Enables time slot connection within the current Megaplex or to another Megaplex in the
net:
Direct (Full) - Time slot connection within the current Megaplex
Fractional - Time slot connection to another Megaplex in the net
Connection
The connection group parameters are enabled only when Mediation=Direct
Connect Type Type of connection:
TDM Service, TDM User
Connect Mux Megaplex in the net which is connected to the selected port
Connect Slot Slot in the connected Megaplex that is connected to the selected port
Connect Port Port in the connected Megaplex that is connected to the selected port
Agent Port Level Operations 2-53