System information

RADview-PC/TDM Megaplex-2100/2104 User’s Manual Chapter 2 Agent Configuration Mode
Table 2-32. V5.1 Data Parameters – MTML-2/E1
Parameter Possible Values / Remarks
Service V5.1
Interface ID V5.1 Interface ID
00000000..16777215
Startup Mode Startup Mode
Sync, Async
Reprovision
Support
Reprovision Support
No: reprovision is not supported
Yes: reprovision is supported
Active Variant Currently Active Variant Id. on this ML
0..127, None
V5.1 State Protocol State of the ML Active Variant
Not Defined: V5.1 is not defined for this interface
Out Of Service: V5.1 interface is Out-of-Service
Sys Start Up: An Establish request arrived at the V5.1 interface
Wait For VID: Variant and the Interface Id were requested during system start-up procedure
Activate PSTN: Activation of the PSTN Data Link was requested during system start-up
procedure
RES1: PSTN restart procedure is in process
In Service: V5.1 interface is in service
RES2: V5.1 is in AN5 state (sends restart complete to all PSTN protocols and changes status
to In-Service)
RES3: V5.1 is in AN6 state (sends restart complete to all PSTN protocols and changes status
to In-Service)
Wait Init: This state is entered when the system's management is in In-Service state, Switch
to a new Variant is received and V5.1 interface will not be restarted
Switch Over: This state is entered when the system's management is in In-Service state,
Switch to a new Variant is received and V5.1 interface will be restarted
Ctrl DL Rel1: This state is entered when the system's management is in In-Service state and
Release Indication is received Timer TC1 is running in this state
Ctrl DL Rel2: This state is entered on reception of Release-Indication in 'RES3' state
Ctrl DL Rel3:
MTML-2/E1 Redundancy Parameters
Table 2-33. Redundancy Parameters – MTML-2/E1
Parameter Possible Values / Remarks
Redundancy
Mode
ML redundancy mode
Dual Cable Parallel Tx: ML card is connected by a separate cable to other Megaplexes
Y Cable: Y Cable connects two MTML cards to two Megaplexes, through one cable (only
applicable for same types CSU or DSU of MTML cards)
Primary Port Primary port
Secondary Slot Secondary slot
Secondary Port Secondary port
Recovery Time
(sec)
Minimum interval in seconds necessary to pass from time MTML card is switched (to
current slot) before next ML switch can occur
1..99
Agent Port Level Operations 2-55