System information

Chapter 2 Agent Configuration Mode RADview-PC/TDM Megaplex-2100/2104 User’s Manual
Figure 2-47. Software Configuration ML–IP (Int. Port)
Table 2-35. Software Configuration –ML–IP (Internal Port)
Parameter Possible Values / Remarks
Connect No, Yes
CAS Enable Enables CAS
Enable (checked), Disable (unchecked)
Routing Protocol None, RIP2, Proprietary RIP
OOS Signal State of the signaling bits when the link is in out-of-service (OOS) state:
Forced Idle – Signaling bits A and B are idle when the link is in out-of-service
state. In addition, if the line type is ESF, signaling bits C and D are also idle.
Forced Busy - Signaling bits A and B are busy when the link is in out-of-service
state. In addition, if the line type is ESF, signaling bits C and D are also busy.
Busy Idle - Signaling bits A and B are busy for 2.5 seconds, then become idle
until the out-of-service state ends. In addition, if the line type is ESF, signaling bits
C and D are idle for 2.5 seconds before switching to busy state.
Idle Busy - Signaling bits A and B are idle for 2.5 seconds, then become busy
until the out-of-service state ends. In addition, if the line type is ESF, signaling bits
C and D are busy for 2.5 seconds before switching to idle state.
Signalin Profile 1, 2, 3, 4, 5
IP Address IP Address
IP Mask IP Mask
2-58 Agent Port Level Operations