System information

Chapter 2 Agent Configuration Mode RADview-PC/TDM Megaplex-2100/2104 User’s Manual
Table 2-41. Testing Parameters (Test per Port Tab)
Parameter Possible Values / Remarks
Slot Slot number of the selected card
IO-1 to IO-12
For MP-2104: IO-1 to IO-5
Port Selected port
external-1 to external-12, internal-1 to internal-12
Card Type Type of card assigned to the selected slot
BERT Pattern
QRSS, 2E23–1, 2E20–1, 2E15–1, 2047, 511, 63, 1M-7S, 1S-7M, Alternate, Mark,
Space
BERT Err Inj. Rate (10E-) The rate of BERT injection: Single, 1, 2, 3, 4, 5, 6, 7
Current
The Current section shows the current testing status in the selected port. In
addition, you can stop a currently running test
Test Currently running test. The Megaplex supports the following tests:
Local Loop, Tone Injection, Remote Loop, External Initialization, Local Loop,
Local and Remote Loop, BERT , Remote Loop on Remote Unit, Remote Loop on
External Unit, Remote Loop on Remote Unit, BERT
Time Left Time remaining, in minutes, until the end of the current test
BERT Count Number of BERT errors counted during current BERT test (applicable only when
BERT is running on the selected port)
New
The New section allows you to activate a diagnostic test if no test is currently
running on the selected port
Test Name of test that you want to initiate. The available options are the same as the
Current Test possible values. If diagnostic testing is not possible on the selected
port, None appears in this field
Duration Desired duration of the new test. Some ports require a time limit to prevent infinite
execution. If the selected port requires a time limit, the default duration appears in
this field when the Testing dialog box initially appears.
1..30 minutes
Other ports do not require a time limit, but you may set a time limit anyway:
infinite (no limit), 1..30
2-70 Port Level Diagnostic Tests