System information

RADview-PC/TDM Megaplex-2100/2104 User’s Manual Chapter 2 Agent Configuration Mode
Figure 2-60. Current Data Dialog Box
The Current Data dialog box shows the amount of time that error(s) exist(s) in the
current measurement interval. Each interval is 15 minutes (900 seconds).
Table 2-45. Current Data Parameters
Parameter Possible Values / Remarks
Slot Slot number of the selected card
IO-1 – IO-12
For MP-2104: IO-1 to IO-5
Card Type Type of card inserted into the selected slot
MTML-2/T1(CSU), MTML-2/T1(DSU), MTML-2/E1(DSU), MTML-2/E1(LTU)
Port Selected port
external-1
Time Elapsed Number of seconds since the beginning of the current interval
Errored Seconds Number of seconds in the current interval in which an event or alarm occurred
SESs Severe Errored Seconds. Number of seconds in the current interval in which at least
320 CRC events or one OOF event occurred
UASs Unavailable Seconds. Number of seconds in the current interval in which a failed signal
state exists. A failed signal state occurs after 10 consecutive severe errored seconds. This
state is cleared only after the Megaplex processes 10 consecutive seconds of data
without an SES
CSSs Controlled Slip Seconds. Number of seconds in the current interval in which at least one
controlled SLIP event occurred
BESs Bursty Errored Seconds. Number of seconds in the current interval in which 2 - 319 CRC
events occurred
Degraded
Minutes
Number of minutes in the current interval in which the bit error rate (BER) exceeded
1x10
-6
Displaying Port Statistics 2-77