System information

RADview-PC/TDM Megaplex-2100/2104 User’s Manual Chapter 1 Edit Configuration Mode
System Level Configuration Operations 1-23
Table 1-10. Legacy Data Parameters
Parameter Possible Values / Remarks
Signaling Profile The profile number selected in the Select Profile dialog box
1 to 5
Rx (ML->IO) column
A
A, B, C, D, Inverse A, Inverse B, Inverse C, Inverse D, 1
, 0
B
A, B, C, D, Inverse A, Inverse B, Inverse C, Inverse D, 1, 0
C
A, B, C, D, Inverse A, Inverse B, Inverse C, Inverse D, 1, 0
D
A, B, C, D, Inverse A, Inverse B, Inverse C, Inverse D, 1, 0
Busy
0000
.. 1111
Idle
0000
.. 1111
Tx (ML->IO) column
A
A, B, C, D, Inverse A, Inverse B, Inverse C, Inverse D, 1
, 0
B
A, B, C, D, Inverse A, Inverse B, Inverse C, Inverse D, 1, 0
C
A, B, C, D, Inverse A, Inverse B, Inverse C, Inverse D, 1, 0
D
A, B, C, D, Inverse A, Inverse B, Inverse C, Inverse D, 1, 0
Configuring R2 Data Profile
Most of the parameters included in an R2 profile can be automatically selected by
specifying a national (country) implementation. In addition, it is necessary to select
the type of link (terrestrial or satellite).
R2 profiles enable the user to specify, for each individual channel (identified by
the main link timeslot to which it is routed), the call permissions: incoming only,
outgoing only, or both.

To set R2 data:
1. From the Signaling Profile Dialog Box, select a profile whose type is R2 CAS
and click <R2 Data…>
The R2 Data dialog box appears. There are three tabs: General, Timers
and Data.
2. Click on the desired tab to configure parameters
3. Click <Set> to add the changes to the NMS database and close the dialog
box.