System information

RADview-PC/TDM Megaplex-2100/2104 User’s Manual Chapter 1 Edit Configuration Mode
System Level Configuration Operations 1-37
Parameter Possible Values/Remarks
Next Hop Indicates IP address to which the Ehternet frame will be sent when the Dest. Name
IP is not in the device subnet
Dest. Bundle Bundle number in the destination Ipmux device
1–2016
Jitter Buffer (µsec) Depth of the jitter buffer (elastic buffer per link whose size is configurable in units
of µs).
300..30,000 µs
ToS IP ToS (Type of Service) assigned to this channel
0
-255
Configures IP ToS field in the IP frames transmitted by the device. Configures the
entire byte – not only the 3 ToS bits. ToS assignment applies to all TDM packets
leaving mux.
TDM Bytes in Frame UDP payload (one-eight) length enabling reduction of Ethernet throughput
48
, 96, 144, 192, 240, 288, 336, 384
VLAN Tagging
No
, Yes
Note: If two bundles use the same VLAN ID and same exit port, VLAN Tagging
should be the same for both
VLAN ID VLAN ID
0
-4000
VLAN Priority VLAN Priority (Enabled only when VLAN Tagging=Yes)
0
-7
Exit Port
External–1
, External–2, Auto
Voice OOS Voice out-of-service code transmitted on voice time slots when the link is
out-of-service. This value must be the same for both ports. To change the code,
type the required code in the edit box
00
-FF (hexadecimal)
Data OOS Data out-of-service code transmitted on data time slots when the link is
out-of-service. This value must be the same for both ports. To change the code,
type the required code in the edit box
00
-FF (hexadecimal)
Far-End Type
Type of the Far-End device (available only for Agents with SW version ≥ 9.xx
E1
, T1-ESF, T1-D4

To change an entry in the Bundle Connection Table:
1. In the Bundle Table, select a bundle and click <Change...>.
The Change Bundle Connection dialog box appears. The Parameters are
the same as those in Table 1-17.
2. Configure desired parameters and click <Set>.