System information

Chapter 1 Edit Configuration Mode RADview-PC/TDM Megaplex-2100/2104 User’s Manual
1-54 Port Level Configuration Operations
Parameter Possible Values / Remarks
Inband Mng Identifier of inband management over the link
Off, FDL or TS0, Dedicated TS, Dedicated TS/PPP, Dedicated FR
Inband Mng Rate
(Kbps)
Data rate of the inband management. Options depend on Inband Mng
NA, 4, 64
Inband Mng Rout
Protocol
Protocol of Inband Mng. Options depend on Inband Mng
None, RIP2, Proprietary
Inband Mng Identifier of inband management over the link.
Off, FDL or TS0, Dedicated TS, Dedicated TS/PPP, Dedicated FR.
Inband Mng Rate
(Kbps)
Data rate of the inband management. Options depend on Inband Mng .
NA, 4, 64.
Inband Mng Rout
Protocol
Protocol of Inband Mng. Options depend on Inband Mng.
None, RIP2, Proprietary.
ML Rdn Tab
Table 1-27. ML Rdn. Tab MTML2/T1
Parameter Possible Values / Remarks
Redundancy
Mode
ML redundancy mode
Dual Cable Parallel Tx: ML card is connected by a separate cable to other Megaplexes.
Y Cable: Y Cable connects two MTML cards to two Megaplexes, through one cable (only
applicable for same types CSU or DSU of MTML cards).
Primary Port Primary Port
Secondary Slot Secondary Slot
Secondary Port Secondary Port
Recovery Time
(sec)
Minimum interval in seconds necessary to pass from time MTML card is switched (to
current slot) before next ML switch can occur.
1..99
Connect Tab
Table 1-28. ML Rdn. Tab MTML2/T1
Parameter Possible Values / Remarks
Mediation Enables time slot connection within the current Megaplex or to another Megaplex
in the net
Direct (Full) - Time slot connection within the current Megaplex
Fractional - Time slot connection to another Megaplex in the net
Connection
The connection group parameters are enabled only when Mediation=Direct
Connect Type Type of connection: TDM Service, TDM User
Connect Mux Megaplex in the net which is connected to the selected port
Connect Slot Slot in the connected Megaplex that is connected to the selected port