System information

Chapter 1 Edit Configuration Mode RADview-PC/TDM Megaplex-2100/2104 User’s Manual
1-56 Port Level Configuration Operations
Table 1-29. SW Cfg>> Tab MTML2/E1
Parameter Possible Values / Remarks
Connect Indicates whether the port should be considered in any of the Megaplex algorithms
No, Yes
Line Type The line type of the interface
E1-MF (G.732S), E1 (G.732N), E1-CRC (G.732NCRC), E1-CRC-MF (G.732SCRC)
Restore Time
(sec)
The time required to restore normal service after the end of a loss of synchronization
condition:
CCITT, 1, 10
<<SW Cfg Tab
Table 1-30. <<SW Cfg Tab MTML2/E1
Parameter Possible Values / Remarks
Idle Code (hex) Hexadecimal code transmitted to fill idle (unused) time slots in frames transmitted
through the selected port:
0 to FF
The following values are not allowed: 0, 8, 10, 12, 21, 24, 42, 49, 84, 92
Inband Mng Identifier of inband management over the link
Off, FDL or TS0, Dedicated TS, Dedicated TS/PPP, Dedicated FR
Inband Mng Rate
(Kbps)
Data rate of the inband management. Options depend on Inband Mng
8, 16, 32, 64
Inband Mng Rout
Protocol
Protocol of Inband Mng
For Inband Mng =Dedicated TS/PPP or Dedicated FR:
None, RIP2, Proprietary
ML Rdn Tab
Table 1-31. ML Rdn. Tab MTML2/E1
Parameter Possible Values / Remarks
Redundancy
Mode
ML redundancy mode
Dual Cable Parallel Tx: ML card is connected by a separate cable to other Megaplexes
Y Cable: Y Cable connects two MTML cards to two Megaplexes, through one cable (only
applicable for same types CSU or DSU of MTML cards)
Primary Port Primary Port
Secondary Slot Secondary Slot
Secondary Port Secondary Port