System information

Chapter 1 Edit Configuration Mode RADview-PC/TDM Megaplex-2100/2104 User’s Manual
1-60 Port Level Configuration Operations
Table 1-34. Software Configuration –ML–IP (External Port)
Parameter Possible Values / Remarks
Auto Negotiation Enable (checked), Disable (unchecked)
Max Capability
Advertised
Defines the maximum capabilities of the interface
Only applicable when Auto Negotiation is enabled (checked)
10BASE-T half duplex mode
10BASE-T full duplex mode
100BASE-TX half duplex mode
100BASE-TX full duplex mode
Default Type Only applicable when Auto Negotiation is disabled
10BASE-T half duplex mode
10BASE-T full duplex mode
10BASE-TX half duplex mode
10BASE-TX full duplex mode
Mng VLAN Tagging Enable VLAN tagging
Yes, No
Mng VLAN ID VLAN ID
1
..4000
This field exist only when Mng VLAN Tagging is Yes. This field does not exist for
external–3 port.
Mng VLAN Priority
0
..7
This field exist only when Mng VLAN Tagging is Yes. This field does not exist for
external–3 port.
Ring Mode Indicates If Ring Mode is enabled or not
Checked (enabled), Unchecked (disabled)

To display/change software configuration parameters for an ML-IP internal
port:
1. In the Card View, click the required port.
2. From the Configuration menu, select Port Info...
The Port Information dialog box appears (Figure 1-51).
3. Click the SW Cfg tab.