Specifications

Optimux-106 Ver. 6.1 Indicators 3-1
Chapter 3
Operation
3.1 Turning On Optimux-106
³ To turn on an Optimux-106 unit with a single power supply:
1. Connect the power cable to the power connector on the rear panel of the
Optimux-106.
2. Connect the power cable to the electric outlet.
The PWR indicator lights in green.
³ To turn on an Optimux-106 unit with two power supply units:
1. Connect each power cable to a power connector on the Optimux-106 rear
panel.
2. Connect each power cable to the electricity outlet.
The PWR indicator lights in green.
During normal operation:
• The PWR indicator lights in green
• The indicator corresponding to the uplink in use, A or B, lights
• All SYNC LOSS front-panel indicators are turned off.
3.2 Indicators
Front Panel Indicators
Figure 3-1 shows the Optimux-106 front panel. Table 3-1 lists the functions of the
front panel indicators.
Figure 3-1 Optimux-106 Front Panel – Plastic Enclosure