Specifications

Chapter 4 Configuration Installation and Operation Manual
4-6 Configuring Optimux-106 for Operation Optimux-106 Ver. 6.1
Configuring the Control Port
The control port is used to connect a console terminal to the Optimux-106
device.
Configuration>System>Control Port
1. Baud rate > (115200 bps)
2. Security Timeout > (10 min.)
3. Pop Alarms > (On)
>
Please select item <1 to 3>
ESC-Previous menu; !-Main Menu; &-Exit
Figure 4-8. Control Port Menu
Table
4-5. Control Port Parameters
Parameter Possible Value (default
value in bold)
Description
Baud rate 9600 bps
19200 bps
38400 bps
57600 bps
115200 bps
The baud rate that matches your management
terminal device.
Security Timeout Integer representing number
of minutes
Default: 10 min.
A timeout value in minutes. This value is the number
of minutes of management inactivity after which
Optimux-106 automatically disconnects from the
management session. To reconnect, press <Enter> on
the management terminal and then log in again.
Pop Alarms On
Off
When POP Alarms is On, new alarms appear at the
bottom of the terminal screen. Regardless of the POP
Alarms setting, the alarms are written to the log file.
4.2 Configuring Optimux-106 for Operation
Configuring Ethernet Port Parameters
Configuring the MNG-ETH port
The MNG-ETH port opion is for the management and user Ethernet configuration
of Optimux-106.
³ To configure MNG-ETH port:
1. From the configuration menu select Physical Layer.
The Physical Layer screen is displayed.