Specifications

Optimux-108 Ver. 6.1 Configuring Optimux-108 for Management 4-1
Chapter 4
Configuration
This chapter illustrates the configuration Optimux-108 screens and explains their
parameters.
Menu trees of the Optimux-108 management software are shown in
Chapter 3 .
4.1 Configuring Optimux-108 for Management
Usually, initial configuration of the management parameters is performed via an
ASCII terminal. Once the Optimux-108 host IP parameters are set, it is possible to
access it via Telnet, ConfiguRAD or RADview for operation configuration. Perform
the following steps in order to configure Optimux-108 for management:
•
Setting the Device Information
•
Configuring IP Host Parameters
•
Configuring Optimux-108 Communities
• Configuring the Network Managers
• Setting up the Managers List
• Controlling Management Access.
Entering Device Information
The Optimux-108 management software allows you to assign a name to the unit,
add its description, specify its location to distinguish it from the other devices
installed in your system, and assign a contact person.
³ To enter device information:
1. From the System menu, select Management.
2. From the Management menu, select Device Information.
The Device Information menu appears (see
Figure 4-1 ).
3. From the Device Information menu, select Name and enter a desired name
for the Optimux-108 unit.
4. Select Location and enter the desired name for the current Optimux-108
location.
5. Select Contact and enter the name, phone, and/or any other details of the
contact person you want to save in this field.