Specifications

Chapter 4 Configuration Installation and Operation Manual
4-2 Configuring Optimux-108 for Management Optimux-108 Ver. 6.1
Optimux-108
Configuration>System>Management>Device Information
Description ... (OP-108 HW Version:0.00/A, SW Version:6.10)
1. Name ... (Optimux-108)
2. Location ... (The location of this device)
3. Contact ... (Name of contact person)
>
Please select item <1 to 3>
ESC-Previous menu; !-Main Menu; &-Exit
Figure 4-1. Device Information Menu
Configuring IP Host Parameters
When you integrate the Optimux-108 into your network, you will need to set the
network parameters of the Optimux-108.
³ To define the IP parameters:
1. From the Management menu, select Host.
The Host menu is displayed (see
Figure 4-2 ).
2. From the Host menu, perform the following:
 Select IP Address to define the host IP address
 Select IP Mask to define the host IP mask.
 Select Default Gateway to set the default gateway IP address
The default gateway must be in the same subnet as the host.
Optimux-108
Configuration>System>Management>Host
1. IP Address ... (0.0.0.0)
2. IP Mask ... (0.0.0.0)
3. Default Gateway ... (0.0.0.0)
4. Read Community ... (public)
5. Write Community ... ()
6. Trap Community ... ()
>
Please select item <1 to 6>
ESC-Previous menu; !-Main Menu; &-Exit
Figure 4-2. Host Menu
Configuring Optimux-108 Communities
For establishing a proper management link, you must specify the SNMP trap, read
and write communities.
Note