Specifications

Installation and Operation Manual Chapter 4 Configuration
Optimux-108 Ver. 6.1 Configuring Optimux-108 for Management 4-5
Table 4-1. User Information Fields
Field Possible
Values
Description
User Name Name of user defined in the device.
Access level RO Read Only. This user can display information,
but cannot modify parameters.
RW Read/Write. This user has full control over the
device and can modify parameters.
Dynamic/Permanent Permanent
Dynamic
Indicates whether this user name is built into
the system or added by an administrator.
Built-in users are permanent.
Configuring Control Port Parameters
Optimux-108 embedded software enables you to configure the serial port parameters,
which include specifying terminal baud rate, controlling pop alarms and security
timeout.
³ To access the Control Port menu:
• From the System Configuration menu, select Control Port.
The Control Port menu appears (see
Figure 4-6 ).
Optimux-108
Configuration>System>Control Port
1. Baud rate > (115200 bps)
2. Security Timeout (10 min.)
3. Pop Alarms (ON)
>
Please select item <1 to 3>
ESC-Previous menu; !-Main Menu; &-Exit
Figure 4-6. Control Port Menu
³ To configure the control port data rate:
1. From the Control Port menu, select Baud Rate.
The Baud Rate menu appears (see
Figure 4-7 ).
2. Select the terminal rate by typing the number corresponding to the desired
value, and pressing <Enter>.
The Baud Rate parameter is masked during Telnet and ConfiguRAD sessions.
Note