Specifications

Chapter 4 Configuration Installation and Operation Manual
4-8 Configuring Optimux-108 for Operation Optimux-108 Ver. 6.1
Optimux-108
Configuration>Physical Layer>Ethernet>Port Number
1. ETH-MNG
2. ETH-USER
>
Please select item <1 to 2>
ESC-prev. menu; !-main menu; &-Exit 1 User(s)
Figure 4-9. Port Number Menu
2. From the Port Number Menu (see Figure 4-9 ) choose ETH-USER.
The Ethernet User menu appears.
Optimux-108
Main Menu>Configuration>Physical Layer>Ethernet
1. Device number > (Local)
2. Port number > (USER-ETH)
3. Administrative status (UP)
4. Port name …()
5. Auto Negotiation . (Enabled)
6. Flow Control > (Enabled)
7. Alarms > (Unmasked)
>
Please select item <1 to 6>
ESC-Previous menu; !-Main Menu; &-Exit 1 User(s)
Figure 4-10. Ethernet USER Menu
3. Select Device Number to select a device (Local or Remote).
4. Select Administrative Status and set the status to either Up or Down.
5. Select Port Name to set a name to the port (up to 15 characters).
6. Select Autonegotiation and toggle between the Enabled or Disabled options.
7. Select Flow Control to toggle between the Enabled or Disabled options.
8. Select Alarms to mask or unmask the USER Ethernet alarms. This option
identifies whether alarms triggered by this Ethernet port are masked or not.
When masked, these alarms are not trapped and are not recorded in the log
file.
Configuring the Fault Propagation
Optimux-108 has an option of Alarm Forwarding (Fault Propagation) of the
USER-ETH port.
³ To configure the fault propagation:
1. From the Configuration menu, select System.