Specifications

Chapter 4 Configuration Installation and Operation Manual
4-14 Performing Additional Tasks Optimux-108 Ver. 6.1
Optimux-108
Inventory
1. Device Number > (Local)
Device type > (Optimux-108)
Boot version … (1.02 mng 10.03)
SW version … (6.10E04)
HW version … (0.00/A_Firmware: 4A Ver. 1.00)
INTERFACES INFORMATION
Link A … (Module not installed)
Link B … (Module not installed)
E1 Channel 1-4 … (COAX, Unbalanced(75ohm))
V.35 … (Smart Serial)
ETH-MNG … (RJ-45, 10/100BaseT)
Dry Contact … (RJ-45)
Control Port … (Mini USB 5, RS-232)
PS A type > (AC/DC)
PS B type > (AC/DC)
>
Please select item <1 to 1>
ESC-prev. menu; !-main menu; &-exit 1 user(s)
Figure 4-17. Inventory Screen for Optimux-108 with V.35 User Port
Displaying Optimux-108 Status
The Optimux-108 software provides access to the following status information:
• System level – MAC address, connection status, system uptime period, link
protection (redundancy) status
• Physical ports status – Uplink, E1 tributary ports, Ethernet ports
(Management and optional User), optional V.35 user port
The status information is available via the Monitoring menu.
³ To access the Monitoring menu:
• From the Main menu, select Monitoring.
The Monitoring menu appears (see
Figure 4-18 ).
Optimux-108
Monitoring
1. System >
2. Physical Layer >
ESC-prev. menu; !-main menu; &-exit 1 user(s)
Figure 4-18. Monitoring Menu
Displaying System Status Information
The System menu specifies MAC address of the Optimux-108 unit and system
uptime period, and provides access to the information on the interface
connection status, and link protection (redundancy) status. For description of
Optimux-108 system messages, which are displayed via the Event Log and Active
Alarms screen, refer to
Chapter 5 .