Specifications

Installation and Operation Manual Chapter 1 Introduction
Optimux-34 Ver. 2.81 Technical Specifications 1-11
User Ethernet Port
Physical Interface 10/100BaseT
Data Rate 10/100 Mbps
Transmission Mode • Full/half-duplex
• Autonegotiation enable/disable
• Multicast frames enable/disable
• Flow Control and Backpressure enable/disable
Bridge Parameters • Data transfer rate: up to 32 Mbps maximum
• 2K supported addresses
• Supported frame size: up to 1536 bytes
• Throughput: up to 60,386 pps (32 Mbps
data transfer rate, 64-byte frames)
• Latency: 30 μsec (32 Mbps data transfer
rate, 64-byte frames)
• Compatible with IEEE 802.3, 802.3x, 802.3u,
802.1p and 802.1q (802.1D relevant parts)
• Fault propagation in LAN in case of WAN
error (optional)
• Connector: RJ-45
Power Number of Supplies One or two (power sharing)
Power Supply 100-240 VAC, 0.25A
or
-48 VDC, 0.35A
Power Consumption AC: 32 VA max
DC: 13W max
Unit Indications
and Alarms
Unit Indications See Table 3-1.
Dry Contacts
• Maximum Ratings: 1A, 60 VDC, 30 VAC
• Major alarms: Power off; E1 loss of signal; E3
loss of frame on the active link; E3 loss of
signal on the main link; E3 loss of signal on
the backup link in Automatic/Manual
redundancy mode; backup link does not
install in Automatic/Manual redundancy mode.
In redundant power supply mode: one power
supply is faulty; self-test fail.
• Minor alarm: Power off, AIS on E1 input line,
AIS on link input
• Connector: 9-pin D-type female