Specifications

Chapter 2 Installation and Setup Installation and Operation Manual
2-2 Identifying Optimux-34 Modules Optimux-34 Ver. 2.81
• AC power supply cable
• Special DC power supply cable
• CBL-SMB-BNC/M adapter cable (if an E3 electrical interface is ordered)
If the 1U Optimux-34 is ordered with an unbalanced E1 interface, then 16 cable
adapters CBL-RJ45/2BNC/E1/X are supplied.
2.3 Required Equipment
The following equipment is required to install Optimux-34:
• Fiber optic cables (for optical uplink interface)
• RJ-45 E1 connector cables (for balanced tributary interface)
• RJ-45 Ethernet connector cable category 5
• Philips screwdriver (for installation in 19-inch rack).
2.4 Mounting the Unit
Optimux-34 is designed for installation as a desktop or wall-mounted unit. It may
also be mounted in a 19" rack.
• For rack mounting instructions, refer to the
RM-34 Kit Installation Manual .
• If Optimux-34 is to be used as a desktop unit, place and secure the unit on a
stable, non-movable surface.
Refer to the clearance and temperature requirements in
Site Requirements and
Prerequisites
.
2.5 Identifying Optimux-34 Modules
Table 2-1 lists the modular construction of the Optimux-34 unit. Use this to
identify the modules supplied.
Not
e