Specifications

Optimux-34 Ver. 2.81 Optimux-34 Controls and Indicators 3-1
Chapter 3
Operation
3.1 Turning On Optimux-34
³ To turn ON the Optimux-34 unit:
Use a power cable to connect the Optimux-34 unit to the mains.
For the first operation and before synchronization of two units, declare the link
redundancy in the same configuration for both units. In addition, declare the
timing for both units in a valid configuration (i.e., not both units on Loop Back
Timing – LBT).
3.2 Optimux-34 Controls and Indicators
This chapter presents information and description of the Optimux-34 front panel,
controls and how to turn on the Optimux-34 unit.
Front Panel Controls
The Optimux-34 front panel provides the LED indications and the connections to
the Ethernet LAN, V.35 interface and to the E1 channels as shown in
Figure 3-1 ,
Figure 3-2 . Table 3-1 lists the functions of the LEDs, switches, and connectors
located on the Optimux-34 front panel.
Optimux-34 is available in 1U and 2U-high models with optional alarm and V.35
interface connectors as shown in the following figures:
Figure 3-1. Typical 1U-high Front Panel with Optional Alarm and V.35 Connectors
Note