Specifications

Installation and Operation Manual Chapter 3 Operation
Optimux-34 Ver. 2.81 Optimux-34 Controls and Indicators 3-3
Table 3-1. Optimux-34 Front Panel Controls and Indicators (Cont.)
Name Control State Function
MNG-ETH
LINK/ACT
Indicator ON (yellow) Indicates that the link is up on the Management port.
Blinking
(yellow)
Indicates that LAN traffic is actively being transferred via the
management port.
OFF Indicates that the link is down on the Management port.
MNG-ETH
100
Indicator ON (green) Indicates that actual traffic speed on the management port is
100 Mbps
OFF Indicates that actual traffic speed on the management port is
10 Mbps
USER-ETH
LINK/ACT
Indicator ON (yellow) Indicates that the link is up on the USER Ethernet port.
Blinking
(yellow)
Indicates that LAN traffic (RX or TX) is actively being transferred
via the management port.
USER-ETH
100
Indicator ON (green) Indicates that actual traffic speed on the USER Ethernet port is
100 Mbps
OFF Indicates that actual traffic speed on the USER Ethernet port is
10 Mbps
SYNC LOSS 1-16 Indicator ON (red) Indicates that a loss-of-signal has been detected on the
respective channel of the E1 interface.
AIS 1-16 Indicator ON (yellow) Indicates that an alarm indication signaling has been detected
on E1 port
Ports1-16 Connector – Connects E1 port of the E1 module to the E1 network
V.35 Port Connector – Connects V.35 port of the V.35 module to the V.35 line
SFP Slot A Connector - Connects the SFP module to the main board at slot A
SFP Slot B Connector - Connects the SFP module to the main board at slot B
ALARMS Connector – Connects the dry contacts of the Major and Minor alarm relays
to a remote monitoring site
CONTROL/MNG Connector – Connects the V.24/RS-232 management port to an ASCII
terminal
MNG-ETH Connector – Connects the Ethernet port to the Management port
USER-ETH Connector – Connects the Ethernet port to the USER port
PS A Connector – Connects the Optimux-34 to the AC mains or to the DC power
source
PS B Connector – Connects the Optimux-34 to the AC mains or to the main DC
power source