Specifications

Chapter 3 Operation Installation and Operation Manual
3-4 Default Settings Optimux-34 Ver. 2.81
Normal Indications
During normal operation, the LED indications shown in Table 3-2 should appear:
Table 3-2. LED Indications
LED State Indicates
PWR ON, green Power supplies of the Optimux-34 unit active
FLT OFF –
TST OFF –
100 ON, green ON if actual traffic speed is 100 Mbps
OFF if actual traffic speed is 10 Mbps
LINK/ACT Blinking, yellow Ethernet port traffic
SYNC LOSS OFF, Red Loss of receive signal on E1 ports
AIS OFF, Yellow AIS received on E1 ports
3.3 Default Settings
Table 3-3 lists the default settings of the Optimux-34 configuration parameters.
Table 3-3. Default Settings
Type Parameter Default Value
System
Device Information Name Optimux-34
Location The Location of the Device
Contact Person Name of Contact Person
Host IP address 0.0.0.0
IP mask 0.0.0.0
Default gateway 0.0.0.0
Read Community public
Write Community private
Trap Community public
Management Access Telnet All
SNMP All
Web All
Control Port Baud rate 115200
Security timeout 10