Specifications

Optimux-34 Ver. 2.81 Configuring Optimux-34 for Management 4-1
Chapter 4
Configuration
4.1 Configuring Optimux-34 for Management
Configuring Management Parameters
Optimux-34 can be managed from a workstation located on a LAN connected to
the unit's MNG-ETH port. To establish a proper connection, it is necessary to
configure the following parameters: host
IP Address, IP Mask, Default Gateway,
Traps, Read community,
and Write community .
Changes made to SNMP parameters take effect immediately.
Configuring the Ethernet Management Port
The Ethernet option is for the configuration of the management Ethernet port in
the Optimux-34 device.
1. From the Configuration menu, select Physical Layer.
The Physical Layer menu is displayed.
2. From the Physical Layer menu, select Ethernet.
The Ethernet menu is displayed (
Figure 4-1 ).
The Ethernet menu may display the configuration for either MNG-ETH or
USER-ETH depending on the Port Number selected. To toggle between
configurations, select Port Number and the Port Number Menu appears.
Configuration>Physical Layer>Ethernet
1. Device Number > (Local)
2. Port Number > (MNG-ETH)
3. Auto negotiation (Enable)
4. Flow Control (Enabled)
5. Alarms (Unmasked)
>
Please select item <1 to 5>
ESC-prev.menu; !-main menu; &-exit 1 user(s)
Figure 4-1. Ethernet Menu
Table
4-1 describes the fields in the Ethernet Management menu.
Note