Specifications

Chapter 4 Configuration Installation and Operation Manual
4-6 Configuring Optimux-34 for Operation Optimux-34 Ver. 2.81
Table 4-5. Host Values
Field Description Possible Values Visibility
IP Address The IP address of the host interface 0.0.0.0 to
255.255.255.255
Always on
IP Mask The host inteface subnet mask 0.0.0.0 to
255.255.255.255
Always on
Default Gateway The gateway IP address used for routing the
outgoing IP packets
0.0.0.0 to
255.255.255.255
Always on
Read Community The read community containing up to 20 characters Public Always on
Write Community The write community containing up to 20 characters NULL Always on
Trap Community The trap community containing up to 20 characters NULL Always on
2. From the Host screen, select IP Address and enter the IP address to set the
IP address of the Optimux-34 unit.
3. Select IP Mask and enter an IP LAN mask.
4. Select Default Gateway and enter the IP address of the gateway.
5. Select Read Community to set the read community.
6. Select Write Community to set the write community.
7. Select Trap Community to set the trap community.
Setting up the Manager List
The manager list defines the network management stations that will receive traps
from the SNMP agent of the Optimux-34. Up to ten managers can be defined. A
manager can be masked to temporarily prevent it from receiving traps.
By default, any remote management terminal is allowed to change the
configuration of the Optimux-34. You may enhance the security of the site by
limiting remote management to specific management terminals or nodes. The
Manager List lists the network nodes from which management may take place.
³ To define the manager list:
1. From the Management menu, (see
Figure 4-4 ), select Managers List.
The Managers List screen is displayed.