Specifications

Installation and Operation Manual Chapter 4 Configuration
Optimux-34 Ver. 2.81 Configuring Optimux-34 for Operation 4-13
4. Choose the redundancy mode you want to use: Auto, Manual or Off (refer to
Chapter 3 for details).
Configuring the Physical Ports
Configuring the Ethernet User Port
³ To configure the Ethernet User port:
1. From the Ethernet menu (
Figure 4-1 ), select Port Number.
The Port Number menu opens.
2. From the Port Number Menu, choose USER-ETH.
The Ethernet User menu appears.
Configuration>Physical Layer>Ethernet
1. Device Number > (Local)
2. Port Number > (USER-ETH)
3. Administrative Status (Up)
4. Port Name ...()
5. Auto Negotiation > (Enable)
6. Flow Control > (Enable)
7. Rate Limit > (0 Mbps)
8. Alarms > (Unmasked)
>
Please select item <1 to 8>
ESC-prev.menu; !-main menu; &-exit 1 user(s)
Figure 4-14. Ethernet User Menu
Table
4-11 describes the fields in the Ethernet User menu.
Table 4-11. Ethernet User Values
Field Description Possible Values Visibility
Device Number The device value Local
Remote
Always
Port Number The Fast Ethernet port number MNG-ETH
USER-ETH
Always
Administrative Status Port status Up
Down
Always
Port Name User chosen Always
Autonegotiation Enables Autonegotiation Enabled (1)
Disabled (2)
Always
Flow Control Configures the default administrative
PAUSE mode for this interface.
Disabled
Enabled
Always