Specifications

Chapter 4 Supervisory Port Software Configuration Optimux-XLT1 Installation and Operation Manual
4-10 The Optimux-XLT1 Interface
The tributaries and fiber optic settings can be set from the terminal (see Changing
the Configuration of the Interface on page 4-10). The applicable tributaries and
fiber optic interface states are indicated in Table 4-3.
Table 4-3. T1 and Fiber Optic Interface States
State Indicates
No loop No loop is set
Local loop A local loop is set. An T1 local loop applies to all ports of an T1 module (see
Troubleshooting Instructions on page 5-3 for details)
Remote loop A remote loop is set. A T1 remote loop applies to a single port of a T1 module (see
Troubleshooting Instructions on page 5-3 for details). Remote loop on fiber optic link is
not available.
The Ethernet port is set from a DIP switch. The applicable settings are:
Table 4-4. Ethernet Setting
Setting Indicates
Half duplex Ethernet port operates in half duplex
Full duplex Ethernet port operates in full duplex
Changing the Configuration of the Interface
➤ To change the configuration of the monitor interface:
4. Type 3 in the Interface Menu screen.
The Change Interface Configuration screen appears.
LOCAL DEVICE
CHANGE INTERFACE CONFIGURATION
------------------------------
NOTE: To change the configuration of the interface, select it
in the next format:
- decimal number from 1 to 5 for modules,
(1 for module A, 2 for module B,..., 5 for E3 link)
- decimal number from 1 to 4 for ports
- for E3 link port=1 selects main link, port=2 selects backup link.
0. Exit
1. Module module A
2. Port port 1
3. Test Configuration Filter enabled
Enter your choice:
Order from: Cutter Networks
Ph:727-398-5252/Fax:[phone]
www.bestdatasource.com