Specifications

Chapter 4 Supervisory Port Software Configuration Optimux-XLT1 Installation and Operation Manual

4-24 The Optimux-XLT1 SNMP Parameters

2. Type 1 to input an inband IP address.

3. Type 2 to insert a subnet mask.

4. Type 3 to set a default gateway.

5. Type 0 to exit the IP Addresses screen.

For changes to take effect, the unit must be reset.

Viewing Community Names

➤ To view the community names:

1. Type 2 in the SNMP Parameters screen.

The Community Names screen appears.

LOCAL DEVICE

COMMUNITY NAMES

---------------

NOTE: Change will take effect after RESET only.

0. Exit.

1. View & change Trap community name: public

2. View & change Read-only community names: public

3. View & change Read-write community names: 1

Enter your choice:

2. Type 1 to view and modify a Trap community name.

3. Type 2 to view and modify a Read-only community name.

4. Type 3 to view and modify a Read-write community name.

5. Type 0 to exit the Community Names screen.

Note

Order from: Cutter Networks

Ph:727-398-5252/Fax:727-397-9610