System information

User’s Manual Chapter 2 Installation and Operation
Optimux-34 Ver. 2.81 Using the Graphical User Interface (GUI) 2-13
Name Color LED On LED Off Blinking
Sync Loss B Red Signal Loss detected on
the main link
If the following
conditions occur at the
same time:
• Redundancy mode is
defined as Manual
• Link B is defined as
the main link.
• Link B is OK (no
Signal Loss or AIS)
• Link A is active.
AIS B Yellow AIS is detected on the
main link.
MNG-ETH:
100
Green 100M mode 10M mode
MNG-ETH:
Link/Act
Yellow Management Ethernet
link is up
Management Ethernet
link is down
Management Ethernet
link is up and the Rx/Tx
frames are transmitted
USER-ETH:
100
Green 100M mode 10M mode
USER-ETH:
Link/Act
Yellow User Ethernet link is up Data Ethernet link is
down
User Ethernet link is up
and Rx/Tx frames are
transmitted
Sync Loss
on E1 ports
Red Signal Loss is detected
on the respective E1
port
Port not in use or the
port is not physically
connected
AIS on E1
ports
Yellow AIS is detected on
respective E1 port