System information

Optimux-34 Ver. 2.81 Applications 4-1
Chapter 4
Configuring Typical
Applications
This chapter describes the procedure for the configuration of a typical
application, which is performed after completing the physical installation of the
units. This procedure is accomplished through the use of the RADview/TDM
Optimux-34.
4.1 Applications
The following sections describe typical Optimux-34 applications.
Backbone Data Network Application
In the application shown in the following figure, a coax link module is installed in
the Optimux-34 unit that is physically close to the public network. The other
Optimux-34 is equipped with a fiber optic link interface to extend its transmission
range. The optical link is connected to a fiber optic modem (FOM) with an E3
interface, which is coupled to the public network via a coaxial cable.
Figure 4-1. Optimux-34 Backbone Access Application