System information

Optimux-34 Ver. 2.81 RADview/TDM Optimux-34 Overview 1-1
Chapter 1
Introduction
This chapter provides an overview for managing Optimux-34 using the
RADview/TDM SNMP Optimux-34 management solution. It introduces the
graphical user interface. It is assumed that you are familiar with basic
RADview/TDM operations. For more information about basic RADview-NMS
operations, refer to the
RADview/TDM (PC) or (UNIX) User's Manual.
1.1 Optimux-34 Overview
Optimux-34 provides a simple, flexible, and cost-effective solution for
transporting multiple E1 channels, high-speed, and Ethernet traffic over an E3 link
to distances of up to 110 km (68 miles). The E3 link is available with multimode,
single mode fiber, single mode over single fiber, or SFP-based interfaces. It
supports redundant and modular main links and power supplies.
Optimux-34 provides 16 E1 channels, high speed and Ethernet traffic, into one E3
copper or fiber optic link.
Optimux-34 provides optional wide-range modular redundant power supplies. The
optional second main link provides backup using automatic switchover upon link.
The optional second power supply provides power redundancy for fail-safe
operation.
Optimux-34 has various optical interfaces (based on SFP interfaces) available for
both active and backup main link(s).
Optimux-34 transmits the clock of each E1 channel independently.
As a local device, Optimux-34 can be connected to an Optimux-34 device or to
Optimux-XLE1.
1.1 RADview/TDM Optimux-34 Overview
This chapter explains the steps required to get the RADview/TDM SNMP
management system for Optimux-34 version 1.0 up and running. It describes the
graphical user interface, configurations, security and fault management. Specific
tasks possible with RADview/TDM Optimux-34 are dealt with in the subsequent
chapters in this manual. All the configurations and management support in this
manual are tasks that can be performed with RADview only and not with the
terminal.
The RADview/TDM SNMP management system for Optimux-34 provides you with
all the tools necessary to monitor the performance and configure the device
parameters for its local and remote devices.