System information

Chapter 7 Fault Management User’s Manual
7-2 Handling Alarms and Traps Optimux-34 Ver. 2.81
Figure 7-1. Fault Menu – System Level
List of Alarms and Events
The Optimux-34 alarms are described in Table 7-1 .
Table 7-1. Optimux-34 System Alarms
Code Message on terminal Description Severity
1 PS A fail No voltage in power supply A. Major
2 PS B fail No voltage in power supply B. Major
3 Remote connection FAIL A managment connection could not be established with
the remote device.
Major
4 Redundancy not
available
Redundancy mode is set to AUTO or MANUAL but the
second link is not installed.
Major
30 ETH Integrity fail Failure in Ethernet management port
integrity or in the fast Ethernet integrity.
ETH-MNG
ETH
Major
31 Signal Loss Signal loss detected on uplinks or
channels.
E1
LINK
Major
33 Rx AIS Received AIS on the uplinks or the
channels.
E1
LINK
Minor
The Optimux-34 events are described in Table 7-2 .
Table 7-2. Optimux-34 Events
Code Event Description
100 Software process failed Failed to process software download.
101 Buffer overflow The event log buffer exceeded its maximum size and new events are
written over the old ones.
Viewing All Active Alarms
The All Active Alarms command enables you to view all active alarms of the local
and remote devices in the system.
 To view all active alarms for the system:
1. In the RADview/TDM Optimux-34 window, select the system.
2. On the menu bar, click Fault > All Active Alarms.