System information

Chapter 2 Installation and Operation User’s Manual
2-2 Using the Graphical User Interface (GUI) Optimux-34 Ver. 2.81
2.4 Using the Graphical User Interface (GUI)
From the Optimux-34 View window, you can configure and monitor the entire
Optimux-34 system elements.
Optimux-34 View Window
The RADview/TDM SNMP for Optimux-34 View window displays a dynamic
graphical representation of a local Optimux-34 front panel and a connected
remote Optimux-34 standalone front panel. The view includes the links/ports,
their operational and communication status, and the device’s LED indicators’
status.
• The IP Address of the Remote unit, which appears at the top of the screen, is
shown similar to the address of the Local unit, although each unit has a
different address. You can see different addresses only in the caption under
a SNMPc (PC environment), after you have connected a link between the two
relevant icons on the SNMPc map.
• The remote device display will be according to the far-end type. If the far-end
type is unknown, the NMS will display a box with only the word “Unmanaged”
within it.
• If the remote unit is disconnected, all remote device ports will not be
selectable and the line icon connecting the local and remote devices will be
“broken”, the display is zoomed with an “Unmanaged” message on it.
• If the local unit is a card, then only the local unit appears in the Optimux-34
window.
• If the local unit is a standalone, then the remote unit also appears in the
Optimux-34 window.
Figur e 2-1. Optimux-34 View Window
Note