Instructions / Assembly

Kayak Tall Stand
Assembly Instructions:
1.
2.
3. Connect your two posts with the two cross bars (E):
45mm bolts (H), washers (J) and nuts (K).
- Next, attach a leg brace (D) to each side of the lower
post (C) using a 50mm bolt (I) to connect both leg
braces to the lower post (C). Use a 45mm bolt (H)
when connecting to each leg (A).
- Finally, screw in 3 leveling feet (G) in the three holes
located at the bottom of each leg (A).
- Repeat this step for other post assembly
- Stand one of your posts up and thread the cross bars (E)
in each hole on legs (A) and secure them with a washer
(J) and a nut (K). DO NOT tighten all the way until the
third cross bar (E) is connected (Figure 2).
- Stand your remaining post up and line up the cross bars
(E) with the predrilled holes on the legs (A) and secure
them with a washer (J) and a nut (K).
- The third cross bar (E) connects the two lower posts (C).
Secure in place with a washer (J) and a nut (K) (Figure 3).
- Tighten all six cross bar (E) nuts (K).
Copyright © 2017 DTX International
www.RadCycleProducts.com
Unpack your kayak stand and ensure all the parts are there.
Constructing the two posts (Figure 1):
- Connect the leg (A) to the lower post (C) with two
Figure 1
Figure 3
Parts List
A. Leg ( )
B. Top Post (2)
C. Lower Post (2)
D. Leg Brace (4)
E. Cross Bar (5)
F. Couplers (2)
G. Leveling Feet ( )
H. 45mm Bolts ( )
I. 50mm Bolts ( )
J. Washers ( )
K. Nuts ( )
L. Foam Blocks (4)
M. Arms (8)
Figure 2