User's Manual

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received, includ-
ing interference that may cause undesired operation.
RF Exposure Information
FCC RF Exposure requirements: The highest SAR value reported under this
standard during product certification
for use next to the head with the minimum separation distance of 0mm is 0.640W/Kg. This transmitter must not be
collocated or operating in conjunction with any other antenna or transmitter.
This product is compliance to FCC RF Exposure requirements and refers to FCC website https://apps.fcc.gov/
oetcf/eas/reports/GenericSearch.cfm search for FCC ID: 2AS98C2
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following
two conditions: (1)this device may not cause interference, and(2) this device must accept any interference, including
interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables auxappareils radio exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes :(1) l’appareil ne doit pas produire de brouillage, et(2)
l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible
d’en compromettre lefonctionnement.
This EUT is compliance with SAR for general population/uncontrolled exposure limits in IC RSS-102 and had been
tested in accordance with the measurement methods and procedures specified in IEEE 1528 and IEC 62209. This
equipment should be installed and operated with minimum distance 0 mm between the radiator and your body. This
device and its antenna(s)must not be co-located or operating in conjunction with any other antenna or transmitter.
Cet
appareil est conforme aux limites d’exposition DAS incontrôlée pour la population générale de la norme CNR-
102 d’Industrie Canada et a été testé en conformité avec les méthodes de mesure et procédures spécifiées dans
IEEE 1528 et IEC 62209. Cet appareil doit être installé et utilisé avec une distance minimale de 0 mm entre i’émetteur
et votre corps. Cet appareil et sa ou ses antennes ne doivent pas être co-localisés ou fonctionner en conjonction
avec tout autre antenne ou transmetteur.
C2-Quicktart-20190617a.indd 2 2019-06-17 11:44