Installation Manual

Radarfind Corporation

October 2008 V2 Collector and Remote Radio Installation Instructions Page 6

Collector Installation

Preparing for Collector Installation

Site Selection Criteria

The selection of the mounting location for the Collector and routing of wiring must be accomplished under

the direction of the facilities engineer and the safety engineer responsible for the proposed building or

location.

The Collector installation location must be indoors and protected from all weather and water. The

mounting surface must be 3/4" plywood (or equivalent) for secure and safe attachment. It is

recommended that the location be in a secured area such as a locked electrical or IT utility closet.

Equipment Connections

Fig 4 – Collector C22-2812 Front panel

MCU-0 – Microprocessor 0 indicators A-0/1 – Remote Radio A connection

MCU-1 – Microprocessor 1 indicators B-2/3 – Remote Radio B connection

Ethernet – Network connection C-4/5 – Remote Radio C connection

48 vdc – Auxiliary power supply D-6/7 – Remote Radio D connection