Installation Manual

Radarfind Corporation

12/5/2008 PLM Reader Installation Instructions Page 4 of 10

Preparing for Installation

Note: Read all instructions before installing or operating this equipment.

Site Selection Criteria

The selection of the mounting location for the reader and the method of connecting it into the

existing electrical system must be accomplished under the direction of the facilities engineer and

the safety engineer responsible for the proposed building or location.

The installation location must be indoors and protected from all weather and water. All provided

mounting fasteners must be used for secure and safe attachment.

Equipment Assessment

Caution:

If the equipment is damaged, do not attempt to install or operate it.

1. When the equipment arrives, unpack the unit(s).

2. Check for damage that may have occurred in transit.

3. Contact the carrier immediately to file a claim stating the extent of the damage, or contact

Radarfind customer service for repair or replacement.

4. Review the following checklist to ensure that all necessary materials are available for

installation.

 Reader unit

 2—3/4” #6 screws – For mounting Reader

to existing electrical box. Wired Reader only

 4—hollow wall “Polly” anchors

 4—3” #6 screws for use with the “Polly” wall

anchors

 4—plastic mounting hole plugs