Installation Manual

Radarfind Corporation

12/5/2008 PLM Reader Installation Instructions Page 5 of 10

Installing a RadarFind Plug-in Reader

Warning: ALWAYS confirm that Location ID label on top of Reader matches

Location ID on map for where Reader will be installed. If it is necessary to

install a Reader in any other location for any reason RadarFind must be

notified immediately.

Note: A RadarFind Reader can only be installed with the ground pin orientation the same

as the existing receptacle. If it is necessary to install a Reader 180 degrees off-axis from

the existing receptacle the orientation of the existing receptacle must be reversed by an

electrician.

Plug-in Installation Procedure

1. Unscrew Reader receptacle plate screw approximately ¾”

2. Remove existing receptacle cover plate.

3. Plug Reader into existing receptacle

4. Level Reader and mark wall for four corner

mounting anchors.

5. Remove Reader.

7. Insert included wall anchors at punch marked locations, tighten

until securely compressed into wall, then remove screws from

anchors and discard

. (The heads on the anchor screws are too large to be

used in the Reader)

8. Plug Reader into receptacle.

9. Insert and secure 4 corners using the (4) 3” #6 screws,

tighten to 12 inch pounds.

10. Tighten Reader receptacle cover plate screw

11. Plug four corner holes with plugs provided.