Installation Manual

Radarfind Corporation

12/5/2008 PLM Reader Installation Instructions Page 6 of 10

Hard wiring a Reader

In places where the Reader must be installed off-axis to the receptacle or over a quad

box the Reader Plug-Sert must be removed and the Reader must be wired directly into

the receptacle box.

Removing the Plug-Sert from Reader

1. Remove Reader back plate

2. Remove Reader cover plate

3. Loosen Plug-Sert wire tap screws, from

the bottom front of the Reader behind

the receptacle

4. Pull Reader tap wires out of Plug-

Sert from inside the back of the

Reader

5. Remove receptacle mounting

screws

6. Pull the Plug-Sert out of the front

of the Reader

7. Feed Reader tap wires through slots

in Reader cavity

8. Replace Reader back plate

9. Proceed with wired Reader instructions

on next page.