Installation Manual

Radarfind Corporation

12/5/2008 PLM Reader Installation Instructions Page 7 of 10

Hard wired Reader Installation Procedure

1. Turn off the power to the outlet.

2. Remove the existing receptacle cover plate and

mounting screw, set aside screws for use later.

3. Unscrew receptacle, save screws for later use, and pull

receptacle out of box.

NOTE: If Reader orientation is off axis to the existing receptacle or if

the existing receptacle is an quad see Reader mounting adapter

plate 80-000-1019 adapter plate. (Pg. 10 )

4. Start bottom

receptacle

mounting screw from

installation kit into the box hole,

(YELLOW) leaving approx ½”

protruding, cut screw if required

to avoid contact with wires in

the box.

5. Pull receptacle through Reader

from back and place Reader

temporarily over box, sliding

slot in Reader mounting frame

over bottom box screw, level,

and mark corner holes with

punch.

6. Remove Reader. Insert included

wall anchors at punch marked

locations, tighten until securely

compressed into wall, then

remove screws (RED) from

anchors and discard

. (The heads

on the anchor screws are too large

to be used in the Reader)

7. Start top receptacle mounting

screw into the box hole,

(YELLOW) leaving approx ½”

protruding, cut screw if required

to avoid contact with wires in

the box.