Installation Manual

Radarfind Corporation

12/5/2008 PLM Reader Installation Instructions Page 8 of 10

8. Wire Reader into circuit with Reader leads

protruding from rear of Reader.

9. Pass receptacle through reader cavity and tip

Reader onto the protruding box screws (RED) by

sliding slotted end of metal mounting frame onto

bottom screw, tipping the Reader to left and

turning clock-wise onto top screw.

IMPORTANT ! Use caution to assure that no wires

are caught under metal Reader frame.

10. Tilt the Reader

straight, level, and

tighten box screws

loosely.

11. Insert and secure 4

corners using the (4)

3” #6 screws, tighten

to 12 inch pounds.

12. Tighten box screws

(RED) and reinstall

receptacle onto

Reader mounting

bracket using the

original receptacle

screws, tighten to 12

inch pounds.

13. Replace outlet plate and cover four mounting

holes with plastic plugs, provided.

14. Restore power to the outlet.

Note : See Reader mounting adapter plate (Pg. 10 ) for mounting at 90 Degrees to single gang

receptacles or on quad-box receptacles.