Installation Manual

Radarfind Corporation

12/5/2008 A-Tag Installation Instructions Page 6 of 10

Using adhesive pad – Clean the area on the asset with alcohol to ensure a good bond.

Remove white side of the adhesive covering and place on tag base, aligning the hole

in the center of the adhesive over the base locking mechanism. Remove red backing

and apply to asset. (Be sure to leave sufficient clearance at the open end of the base

to insert and remove the tag from the base)

Adhesive Orientation Apply adhesive to base 1st

Adhesive mounting tips for curved surfaces:

If the target location is not completely flat you may need to add strips under the

ends of the adhesive pad (cut the strips from a spare pad)

Building up adhesive to conform to curved substrates