Instructions
29
EN
18.1 Automatic darkness control; conguration of sensitivity
The automatic darkness control is switched on by setting
or changing the sensitivity.
Congure the brightness at the level (twilight) which the
blinds should be closed.
Set the current brightness (twilight) as set
limit and switch on the automatic darkness
control.
1.
+ Simultaneously press the buttons.
2.
The current brightness is now set as the set limit and
the automatic darkness control is activated.
◆ If this value is exceeded, the roller shutters will roll
down to the lower end point.
NOTE
If you intend not to use the automatic darkness control, it
is necessary to unplug the light sensor from the RolloTron
Standard device or deactivate the automatic darkness
control.
OFF
Automatic darkness control OFF
ON
Automatic darkness control ON
Slowly ashing...
◆ ...if the set limit is exceeded.
◆ ...if the current brightness value is
within the measured range while
conguring the set limit.
Rapid ashing
If the current brightness value is outside
the measuring range, the set limit is set to
the measured range limit.
3.
Pay attention to the darkness
control LED.
4.
You can switch the automatic darkness control on and
o as required.
5.
In order to do so, press and hold the
darkness key for approx. 1 second.