Instructions
59
EN
19. Erase all settings, software reset
If necessary, you can erase
all of your settings and re-
turn the RolloTron Comfort
system to its original fac-
tory settings.
1.
Simultaneously press and
hold all four keys for 5 sec-
onds, until all of the icons
are shown on the display.
2.
Next, the device's software
version will be displayed for
a few seconds.
All settings will be erased and
reset to the default factory
settings.
Carry out the settings again
as specified from page 24
onwards (installation wizard).
20. Carry out hardware reset
A hardware reset can be carried out in the event that the
RolloTron Comfort fails to react to commands.
◆ A hardware reset causes the internal power supply to
the RolloTron Comfort to be briey interrupted.
◆ All of the previously congured settings will be
saved apart from the time and date.
IMPORTANT
Never press the reset button when the motor is running, as
otherwise the end points will be modied.
1.
Press the Reset button using a sharp
object (e.g. a paper clip).