Instructions

EN
33
3.a
(16)(10)
(15)
3.b
(10)
(16)
3.c
(10)
(16)
(15)
Mounting the catch with freewheel mechanism (Figures
3
and
.a
) *
1.
Press the side parts of the retaining clip (15) together and pull the
catch (10) off of the drive adapter (16).
IMPORTANT
If the tubular motor is to be operated with automatic end point con-
figuration and obstacle detection, then the catch (10) must be mounted
with free-wheeling action.
Slide the adapter (10) onto the drive adapter (16) so that it can free-
wheel and so that it engages behind the retaining clip (15).
Free-wheeling is given if the catch (10) can be easily turned back and
forth.
Dismounting the catch (Fig.
.c
)
1.
Mounting the catch without freewheel mechanism (Fig.
.b
)
1.
IMPORTANT
It may be necessary to mount the catch (10) without the freewheel
mechanism for very lightweight awnings or for awnings which do not
run easily, in order to avoid premature switch-off.
Slide the adapter (10) onto the drive adapter (16) so that it cannot
free-wheel and so that it engages behind the retaining clip (15).
NOTE
◆ If the catch (10) is mounted without the freewheel mechanism, then
the tubular motor will work without obstacle detection.
* = The catch is supplied pre-installed by the factory.