Instructions

EN
34
STOP
4.a
4.b
Slide the tubular motor into the awning shaft (Fig.
4
)
1.
Never knock the motor (9) with force
into the awning shaft (11).
Doing so will cause serious damage.
First slide the catch (10) into the awning shaft (11). 2. Subsequently press the tubular motor into the awning shaft (11) so
that the adapter (8) is fully inserted into the awning shaft (11).
IMPORTANT
In doing so, ensure that the adapter (8) does not slip off of the Magnetic ring (14)
on the drive head (6) during the assembly process. Otherwise malfunctions may occur,
see page 45.
Preparation for use of precision tubes (Figures
.a
-
.e
)
1. Measure the distance between the adapter (8) and the rear third of the
catch (10) and mark this distance on the precision tube.
RolloTube I-line Sun Medium
2. Saw a groove in the end of the precision tube 1 in order that the cam
 of the adapter (8) can be completely pressed into the tube.
NOTE
◆ There may not be any play between the groove 1 and the cam .
IMPORTANT
◆ Please only use precision tubes made from aluminium.
4.c
3. Slide the tubular motor (9) into the precision tube.
IMPORTANT
The set button (7) for the tubular motor must be easily accessible and the motor cable
(13) must be laid without kinking.
ALUMINIUM
1