Instructions

EN
41
End point adjustment
IMPORTANT
◆ End points must be set in order to switch off the motor when they are reached for
both directions of travel up (▲)/ down (▼).
◆ The tubular motor must be fully installed.
◆ The set button (7) must be easily accessible.
◆ The set lead (j) must be connected to neutral (f) after configuration
of the end points.
You have various options for configuring the end points, which are
described in the following section:
◆ Setting the upper end point automatically (by means of blockage detection) and
manually setting the lower end point.
◆ Manually setting the upper end point and lower end point.
Important relationship between the configuration of the lower end
point and installation of the catch.
◆ If the catch is mounted without the freewheel mechanism, then the tubular motor
will not switch off automatically, as it will not detect obstacles.
◆ If the catch is mounted with the freewheel mechanism, then the tubular motor will
switch off automatically when extending the awning as soon as the freewheel travel
is overcome.
STOP
Risk of injury when adjusting the awning due to crushing of the hands
by the moving awning.
Never reach into the area of the awning shaft and joint arms when the motor is running.
SET
Set button
Change direction of
travel (▲/▼)
Manual adjustment of end points
Initial installation
For initial installation, the engineer can carry out the end point configuration with the
help of the set button (7) on the motor (9) or with a commercially available cord
switch device (20).
Further information can be obtained from the cord switch device operating instructions.
Subsequent modification of the end points with external controllers
If you want to subsequently modify the end points for your tubular motor, you can use
an external switch as set button, as previously shown, or you can use your tubular motor
controller in order to readjust the endpoints.
Key assignment on cord switch device (20)