Instructions

EN
44
Configuring tubular motors
The tubular motors can be individually configured with the help of a cord circuit setting
unit (20).
The following configurations are possible.
◆ Reload the factory settings.
◆ Fabric tensioning (reversing) after the end point has been reached or switching
on/off after obstacle detection
NOTE
Additional settings can be undertaken with the optionally available RT ConfigTool. Please
refer to the information on our Website www.rademacher.de.
Automatic configuration of the upper end point is available again once the factory settings
have been loaded.
NOTE
We recommend undertaking these settings with two persons.
IMPORTANT
The tubular motor may not be in operation.
Loading factory settings during the commissioning process
1.
Additionally switch on the tubular motor (▲/▼). Hold all buttons.
First press the set button (7) on the tubular motor (9) and subsequently press the SET button on the cord circuit
setting device (20) (possibly a second person carries this out). Press and hold both buttons for approx. 10 seconds.
SET
10 s
2. After approx. 10 seconds the tubular motor acknowledges loading of the factory settings by briefly running up and
down. Subsequently release all buttons and switch off the power to the tubular motor briefly.
10 s
1.
2.
+
Factory settings:
End points: No end points stored
Fabric tensioning (reversing) after the
end point has been reached or switching
on / off after obstacle detection: activated
Fabric tensioning (reversing) after the end point has been reached or
switching on / off after obstacle detection
First press and hold the SET button on the cord circuit setting device (20) and subsequently press and hold the up
or down button for 10 seconds.
After 10 seconds the reversing function will be switched on or off.
Factory setting = reversing is switched on.
1.
SET
10 s
+
1. 2.
2.
After approx. 10 seconds the tubular motor acknowledges switching on / off of the reversing function by briefly
starting up.
10 s