Instructions

4343
EN
Reversal of rotational direction
You can subsequently set or correct the rotational direction of connected tubular motors using this
function.
Alternative use for reversal of directional rotation:
Switch over between lighting function and device function
In case of universal actuators for lighting or for devices (e.g. DuoFern universal actuator or DuoFern
socket actuator), reversing the rotational direction switches over between the lighting function and
the device function.
NOTE
◆ Reversal of rotational direction or switching over between the lighting function and the device function
can only be carried out when only one device (actuator) is registered within the selected group;
if more than one component is registered within the selected group then the function is blocked.
◆ Not all devices support the reversal of rotational direction function or switchover between the lighting
and device function. You should therefore check in the operating instructions of the respective device
whether this function is available.
◆ The following applies for manual transmitter 3248 03 61:
If a multichannel actuator is registered (e. g. DuoFern universal actuator) then the reversal of rotational
direction or switchover between the lighting and the device function is always applied to both
channels.