Instructions
4545
EN
▲
1.
Activate “purge“ function
This function deletes all DuoFern end devices that are registered but that no longer react. This could be
necessary, for example, in the case of a faulty device which can no longer be deleted as described above.
◆ All battery powered DuoFern devices are not to be/cannot be deleted in this way.
◆ To delete all DuoFer end devices from the DuoFern Standard manual transmitter, you must perform
the function “Reset delete settings“ (see page 48).
NOTE
Press the “connect” button for approx. 5 seconds until
the green status LED lights up.
The DuoFern Standard manual transmitter now sends a
control signal to all registered DuoFern dend devices. The
devices which do not confirm the signal will be automati-
cally deleted.
Observe the status LED
Green: The purge was successful
Orange flashing: The purge mode is still active